Skip to main content
Skip table of contents

Multiple Grooves

Cycles: Direct Grooving, Z Level, Zig Zag, W type, Finish Groove

Definition

GO2cam has a powerful management of multiple grooves machining.

If you select several profiles as shown on the right, the machining is not optimized. The toolpaths have no link between each other, each groove is machined independently.

We greatly advise you to select only one profile, as shown on the right.

3 options are possible in the parameter Multiple grooves

No

Multiple groove

Undergroove

▶️ You can watch a video showing the Multiple Grooves parameter in action:

T_Multiple_Grooves.png

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.