Cycle: Contouring, Z Level, Finishing
Definition
The user is able to force the tool to use only uphill machining for along surface roughing only.
|
No: the operation is programmed from top to bottom. This is the most used and default mode. |
|
|
Yes: the tool realizes the machining by going up, from bottom altitude to top altitude.
You can program this option only for outside flanks of part or in through pocket. The first plunge may be done below the bottom altitude and consequently some collision may occur with bottom floor. |
|
|
▶️ The video below is based on parameters 2 Ways Path and Upwards Machining.
|