Creation of profiles for straight cut and taper cut by simple click on a solid.
Click on the starting face.
An arrow shows the direction of machining.
You can click the arrow to invert the direction.
Click on the ending face; if you click the same face, the profile will be closed.
A pre-visualization of the profile is displayed: the information of Straight Cut or Taper cut is written on the screen.
You can change the start/end faces of the profile:
[1] Automatic selection: if you click this icon, GO2cam selects the best face for the starting face.
[2] Manual selection: you can click any face of the solid profile.
You can also move the start and/or end point:
Simply click the green element and move it along the face. Drop it on the right position.
Validate with [3] or cancel with [4] .
When you validate, the profile is created.
Notes:
the profile will be automatically recognized by Automatic Threading Point,
later, you can edit and modify the profile with contextual popup (right-click on the profile).
Please note, these errors can depend on your browser setup.
If this problem persists, please contact our support.