GO2cam Production Help
GO2cam Production Help
Breadcrumbs

Auto Finish

Cycle: Contour rework

Definition

This parameter allows to select the type of finish needed on a contour. Three types of finishing are available:

3117repc_2.png

  • None: the cycle rework the angle inferior to 180 degrees in successive passes.
3117repc_1.png

  • Partial: the cycle rework the angle inferior to 180 degrees in successive passes and make a finish only on the acute angle. When there is only one pass, there is no difference between none and partial.
3117repc_3.png

  • Total: the cycle rework the angle inferior to 180 degrees in successive passes and make a finish on total profile.