Skip to main content
Skip table of contents

Flat Face Rework

Cycles: Z Level, Spiral, 3X Z Level, 3X Z Level with Facing

Definition

This parameter enables reworking on flat surfaces based on specific conditions. It activates only when Slope Reworking is set to “Yes”.

None: Flat faces are not computed

All: All flat faces are computed for the reworking cycle

Partial: Define a value in the field. This sets the maximum length for computing rework on flat faces.

image-20260602-114759.png
image-20260602-122751.png

None

image-20260602-122657.png

All

image-20260602-122553.png

Partial (25mm)

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close