Skip to main content
Skip table of contents

Strategy

Cycle: Contouring

▶️ You can watch a video at the bottom of page: Click here

Definition

Choice of the strategy of machining in case of selection of multiple contours. 3 possibilities are given:

By Profiles

  • The contours are machined one after another, this mode avoid too much rapids. The order of passes is shown by the numbers.

By Z levels

  • The machining is done by Z levels, 'jumping' from a contour to another.

By XY Area

  • The machining is done in the X and Y direction. The order of passes can be optimized using the lateral passes option.

▶️ This video explains the different machining strategy available in the contouring cycle.

Machining Strategy.png

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close