Cycles: Pocket Rework, Finish Contour, Finish Reworking, Z Repeat Pocket, Finish Reworking (Shape)
Definition
The reworking cycles is not automatic. It is mandatory to insert values for the 2 parameters below for it to be calculated.
Stock left in roughing
Enter a value corresponding to the XY stock allowance of the roughing machining. It is the thickness of material to be removed in the HSM cycle.
Reference diameter
The material to remove will depend on the previous roughing machining. Reference diameter corresponds to the diameter of the tool used for roughing. This diameter must be greater than the current tool.
|
If you want the rework operation to do more than only reworking, you can enter values a little bigger than reality. |