Skip to main content
Skip table of contents

Double Chamfering Tool

Cycle: Chamfering

Definition

These two parameters enable to use a double chamfer cutter for a chamfering operation.

Note: The parameters are available only if the Double Chamfer Cutter tool is chosen before adjusting the cycle strategy.

Pilot Point

Two points can be piloted for machining, as shown on the image on the right: 1st point and 2nd point.

Back Machining

  • No: machining from the top

  • Yes: machining from the back

Machining from the top with 1st point

Machining from the back with 2nd point

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.